Cisco 500-005 Exam Syllabus Topics:
| Section | Objectives |
|---|---|
| Installation Planning and Site Preparation | - Pre-installation requirements
|
| Network Integration and Connectivity | - Cisco collaboration network integration
|
| Cisco TelePresence Immersive Systems Overview | - TelePresence architecture and components
|
| Testing, Troubleshooting, and Maintenance | - System verification and diagnostics
|
| System Installation and Configuration | - Hardware installation procedures
|
Cisco Installing Cisco TelePresence Video Immersive Systems Sample Questions:
1. Refer to the exhibit.
Under which configuration components is the TFTP server specified?
A) IP Settings
B) Unified CM Settings
C) System Settings
D) Configuration Issues
E) Telephony Settings
F) Network Settings
2. When configuring the Device Information section of a new TX9000 in Cisco Unified Communications Manager, which two selections are required to be checked? (Choose two.)
A) Remote Device
B) Use Device Pool Calling Party Transformation CSS
C) Logged Into Hunt Group
D) Ignore Presentation Indicators (internal calls only)
E) Allow Control of Device from CTI
F) Retry Video Call as Audio
3. When the TX9000 boots up, green progress check marks are displayed on the screen. After successful bootup, six check marks are displayed. Which of these can cause the last check mark to fail?
A) The TX9000 does not have a directory number assigned.
B) The TX9000 cannot find its configuration and boots up the default configuration of a Cisco TelePresence System 500-32.?
C) The TX9000 is experiencing network connectivity issues.
D) The TX9000 is experiencing a compact flash error.
E) The TX9000 was registered as an H.323 endpoint to Cisco Unified Communications Manager.?
4. When a new TX9000 system is being installed, where does the TX9000 obtain its system image?
A) Cisco Unified Communications Manager
B) FTP
C) Cisco TelePresence Video Communication Server
D) Cisco TelePresence Management Server
E) Domain Name Server
5. Refer to the exhibit.
After the image name was specified for the TX9000 under the Cisco Unified Communications Manager Device Defaults screen, and the TX9000 was restarted, the TX9000 failed to upgrade to Cisco TelePresence System 1.9.1. Which of these caused this issue?
A) The image name is incorrect; it is missing the .cop extension.
B) The image name should be specified under the phone load that was filed in the device configuration.
C) The image name should be specified in the Cisco TelePresence System Administration configuration screen under Unified CM Settings.
D) The image name is incorrect; it is missing the .cop.sgn extensions.
E) The TFTP service was not restarted.
Solutions:
| Question # 1 Answer: B | Question # 2 Answer: E,F | Question # 3 Answer: D | Question # 4 Answer: A | Question # 5 Answer: E |
1045 Customer Reviews
Quality and ValueITCertKing Practice Exams are written to the highest standards of technical accuracy, using only certified subject matter experts and published authors for development - no all study materials.
Tested and ApprovedWe are committed to the process of vendor and third party approvals. We believe professionals and executives alike deserve the confidence of quality coverage these authorizations provide.
Easy to PassIf you prepare for the exams using our ITCertKing testing engine, It is easy to succeed for all certifications in the first attempt. You don't have to deal with all dumps or any free torrent / rapidshare all stuff.
Try Before BuyITCertKing offers free demo of each product. You can check out the interface, question quality and usability of our practice exams before you decide to buy.
