HP Unified Wired-Wireless Networks and BYOD Sample Questions:

1. An administrator wants to configure authentication on the HP 830 switch ports that connect to wireless access points. The company policy requires all wireless users to be authenticated using 802.1X authentication. Each port should also allow multiple wireless users to pass 802.1X authentication.
Which port security mode meets these requirements?

A) userLoginSecureExt
B) macAddressElseUserLoginSecureExt
C) macAddressWithRadius
D) userLoginSecure

2. A branch location is deploying standalone wireless access points (APs). What can be used to configure and manage these APs? (Select two.)

A) CLI
B) Web interface
C) IMC/UAM
D) Access Controller
E) IMC/EAD

3. An organization implements an N+1 redundancy for its access controllers (ACs). When the primary AC fails, the access points (APs) successfully fail over to the standby AC. However, when the failed AC comes back in to service, the APs do not switch back to the original AC.
What could cause this to happen?

A) APs determine which AC to connect to based on load.
B) AP Connection priority on the primary AC is not set to 1.
C) APs do not fail back to the original A
D) AP Connection priority on the primary AC is not set to 7.

4. Refer to the exhibit.

An engineer is installing a new access point (AP). The AP has successfully acquired an IP address. The engineer can ping the access controller (AC) from the AP. However the AC is not discovering the AP.
What could cause this problem?

A) The DHCP server has not been set up with option 43.
B) The interface between the AC and the IP network is down.
C) The AC and AP must be in the same subnetwork.
D) The AP and AC are not in the same VLAN.

5. A business deploys a wireless network that includes an HP 10500/7500 module and 120 access points (APs). They plan to increase the number of APs to 250. Which step must be performed in order to register the upgrade's license management feature?

A) On the controller, in the My Networking Windows, select the update licenses option.
B) On the controller, in System view, enterthe command license register AP.
C) On the controller, in User view, enterthe command license register AP.
D) On the controller, in License view, enter the command register AP.

Solutions: